← Back to glossary
Home
GLOSSARY
Geothermal Energy Cost

Geothermal Energy Cost

Performance Metrics
Definition
Geothermal energy cost is what it costs to produce electricity or heat from a geothermal resource, usually stated as levelized cost of energy and dominated by the cost of drilling the wells.

What does geothermal energy cost?

Geothermal electricity is usually compared on levelized cost of energy, which spreads the project's capital and operating cost across the energy it produces over its life. Geothermal sits higher than wind and solar on that measure, and the gap is almost entirely upfront capital rather than running cost.

Is geothermal energy expensive?

It depends on what you compare. Per unit of energy produced, geothermal costs more to build than wind or solar and less to run. It also runs around the clock, so a geothermal plant delivers far more energy per installed megawatt. US geothermal plants averaged a 65.9% capacity factor in 2025, against 33.8% for wind and 24.0% for solar photovoltaic (EIA Electric Power Annual, Table 4.08.B). Compared on energy delivered rather than capacity installed, the gap narrows. See baseload power.

Why is geothermal expensive to build?

The wells. Drilling and completion account for roughly half of a geothermal power project's capital cost, and the money is spent before the project produces anything. A well that comes in slow or needs unplanned trips raises the cost of every unit of energy the plant will ever sell. See geothermal well economics.

What would make geothermal cheaper?

Faster drilling in hard rock, longer tool life and less non-productive time. The US Department of Energy estimates that doubling the average daily drilling rate cuts total well cost by 10 to 15%. See geothermal drilling cost reduction.

Who is working on the drilling cost?

GA Drilling's NexTitan is an autonomous downhole drive tool built for the hard, hot rock geothermal wells run into. It applies weight on bit at the bit and is designed to hold it steady as the rock changes.

To model the cost on a specific well, use the drilling cost calculator.

Estimate what NexTitan could save on your well

Enter your section length, spread rate and bit cost. Get a modeled savings report.

Take the next step

Drill hard rock with NexTitan

Designed for longer oil & gas wells and deeper, hotter geothermal wells.